Pass4cram HPE2-W09 Real Exam Question Answers Updated [Dec 20, 2021]
Easily To Pass New HP HPE2-W09 Dumps with 78 Questions
HP HPE2-W09 Exam Syllabus Topics:
| Topic | Details |
|---|---|
| Topic 1 |
|
| Topic 2 |
|
| Topic 3 |
|
| Topic 4 |
|
| Topic 5 |
|
| Topic 6 |
|
NEW QUESTION 17
You enter this command on an ArubaOS-CX switch:
Switch# show erps status ring 1
Is this what the specified status means?
Solution: The status is Protection, which means that the ring is up and fully connected with the RPL port blocked.
- A. No
- B. Yes
Answer: A
NEW QUESTION 18
Refer to the exhibit.
You want to enable devices in VRF B and VRF C to reach shared resources in VRFA.
is this a valid strategy for meeting this goal?
Solution: Place ad three VRF$ in the same OSPF process on Switch-1.
- A. No
- B. Yes
Answer: A
NEW QUESTION 19
The architect designs a spine and leaf network for a single data center that will use multiple leaf switches as Virtual Tunnel End Points (VTEP). The architect needs to select the type of Integrated Routing & Bridging (IRB) for the solution.
Is this statement about the IRB type true?
Solution: Asymmetric IRB requires a third L3 VNI to route packets between ingress and egress VTEPs.
- A. No
- B. Yes
Answer: B
NEW QUESTION 20
Is this a way that a data center technology can help meet requirements for multi-tenancy?
Solution: Virtual Extensible LAN (VXLAN) enables multiple isolated Layer 3 domains, each with its own routing table, to share a physical network.
- A. No
- B. Yes
Answer: A
NEW QUESTION 21
Refer to the exhibit.
Switch-1, Switch-2, and the router run OSPF on LAG 100, which is a Layer 3 LAG. Does this correctly explain how to control how core-to-access traffic Is forwarded?
Solution: To reduce the amount of traffic sent over the ISI between Switch-1 and Swltch-2. enable active forwarding on LAG 100 on both Switch-1 and Switch-2.
- A. No
- B. Yes
Answer: B
NEW QUESTION 22
Does this correctly describe how the Virtual Switching Extension (VSX) fabric reacts to various component failure scenarios?
Solution: The keepalive goes down, ISL link remains up. Switch-1 and Switch-2 remains up. The Split-recovery mode is disabled. In this case the secondary switch shutdowns Svls.
- A. No
- B. Yes
Answer: A
NEW QUESTION 23
Switch-1 and Switch-2 are AruDaOS-CX switches, which ate part of a Virtual Switching Extension (VSX) fabric. Switch-2 is the primary member. Switch-2 experiences a power failure while Switch-l remains up. Switch-2's power recovers, and Switch-2 reboots.
Solution: Switch-2 wails a period called the link-up delay before it enables Switched Virtual Interfaces (SVls) on its VSX LAGs.
- A. No
- B. Yes
Answer: B
NEW QUESTION 24
Refer to the exhibit.
You are adding a VLAN 30, subnet 10.0.30.0/24 to the network shown in the exhibit. (This network is simplified to just the relevant switches for this item.) This subnet belongs in VRF A, and you have added a Layer 3 VLAN 30 interface attached to this VRF on Switch-1. You want to make the services in this VLAN available to devices in 10.1.20.0/24 in VRF B.
Is this part of a valid setup for meeting these requirements?
Solution: Add a route with this command: ip route 10.1.20.0/24 vlan20 vrf A
- A. No
- B. Yes
Answer: A
NEW QUESTION 25
Can you attach this type of ArubaOS-CX interface to a VRF?
Solution: A physical interface using Layer 2 mode
- A. No
- B. Yes
Answer: A
NEW QUESTION 26
Does this correctly describe the ArubaOS-CX architecture?
Solution: The ArubaOS-CX time-series database helps to support network analytics and troubleshooting.
- A. No
- B. Yes
Answer: A
NEW QUESTION 27
Does this correctly describe how the Virtual Switching Extension (VSX) fabric reacts to various component failure scenarios?
Solution: The ISL and keepalive goes down, and after a few seconds, the keepalive link restores. Switch-l and Switch-2 remains up. The Split-recovery mode is enabled. In this case the secondary switch shutdowns SVls when keepalive is restored.
- A. No
- B. Yes
Answer: A
NEW QUESTION 28
Does this correctly describe routing information advertised by a VXLAN Tunnel Endpomt (VTEP) that uses EVPN?
Solution: IMET routes advertise the MAC addresses that the VTEP has learned locally in a VXLAN.
- A. No
- B. Yes
Answer: B
NEW QUESTION 29
The architect designs a spine and leaf network for a single data center that will use multiple leaf switches as Virtual Tunnel End Points (VTEP). The architect needs to select the type of Integrated Routing & Bridging (IRB) for the solution.
Is this statement about the IRB type true?
Solution: In the Asymmetric IRB egress VTEPs bridge the traffic to the destination networks.
- A. No
- B. Yes
Answer: A
NEW QUESTION 30
Does this correctly describe the ArubaOS-CX architecture?
Solution: The AtubaOS-CX software is based on the ArubaOS-Switch software and adds data center features.
- A. No
- B. Yes
Answer: A
NEW QUESTION 31
An ArubaOS-CX is \ssmq DCBX on Interface 1/1/1. You enter this command:
show dcbx interface 1/1/1
Is this where you can see whether the connected converged network adapter (CNA) has accepted the application priorities advertised with DCBX?
Solution: in the Enhanced Transmission Selection (ETS) Local advertisement section
- A. No
- B. Yes
Answer: B
NEW QUESTION 32
Is this statement about ARP and ND Suppression true?
Solution: Both ARP-Suppression and ND-Suppression are disabled by default.
- A. No
- B. Yes
Answer: A
NEW QUESTION 33
Is this a use case for disabling split-recovery mode on ArubaOS-CX switches in a Virtual Switching Extension (VSX) fabric?
Solution: In situations in which the primary switch fails and then reboots, you want to make the primary switch take over again as the primary switch.
- A. No
- B. Yes
Answer: A
NEW QUESTION 34
......
Latest HPE2-W09 Study Guides 2021 - With Test Engine PDF: https://www.pass4cram.com/HPE2-W09_free-download.html
Get New HPE2-W09 Practice Test Questions Answers : https://drive.google.com/open?id=1l1DgkK4WUgawkNeZCcgN8fcSMmf3zv7y