Pass4cram DEA-5TT1 Exam Questions Real DEA-5TT1 Practice Dumps [Q31-Q52]

Pass4cram DEA-5TT1 Exam Questions | Real DEA-5TT1 Practice Dumps

Verified DEA-5TT1 Exam Dumps Q&As - Provide DEA-5TT1 with Correct Answers

NEW QUESTION 31
Which IPv4 address is in the same network as the IP address 182.15.24.40/23 and assignable to a host device?

• A. 182.15.26.10
• B. 182.15.25.255
• C. 182.15.23.224
• D. 182.15.25.0

Answer: D

 

NEW QUESTION 32
Which BASE-T Ethernet standard specifies a CAT6 cable type?

• A. 10GBASE-T
• B. 5GBASE-T
• C. 10BASE-T
• D. 2.5GBASE-T

Answer: A

 

NEW QUESTION 33
What is the correct sequence of steps when a web browser accesses a web server?

Answer:

Explanation:

 

NEW QUESTION 34
Which port and protocol is used by NTP to communicate?

• A. TCP port 123 for both the source and destination
• B. TCP port 123 for the source and TCP port 80 for the destination
• C. UDP port 123 for the source and TCP port 80 for the destination
• D. UDP port 123 for both the source and destination

Answer: D

 

NEW QUESTION 35
Which IPv6 scope is used for private addressing on a local network?

• A. Area wide
• B. APIPA
• C. Unique local
• D. Global

Answer: C

 

NEW QUESTION 36
Refer to the exhibit.

Switch A and Switch B are connected to each other. Both switches use interfaces Gi1/0/1 and Gi1/0/2.
Switch A has a Spanning Tree priority of 8192 and Switch B has the default priority. Which interface becomes the root port?

• A. Switch B Gi1/0/1
• B. Switch A Gi1/0/2
• C. Switch A Gi1/0/1
• D. Switch B Gi1/0/2

Answer: C

 

NEW QUESTION 37
A network administrator is troubleshooting an OSPF routing issue. There are two paths to a destination network from one switch. In addition, one path is comprised of four 1 Gb links. The other path is comprised of two 1 Gb and two 100 Mb links. The administrator ran several trace routes and notices that the packets are swapping back and forth between the two paths.
Which corrective action must be taken on the switch infrastructure to correct this issue?

• A. Break the paths into multiple OSPF areas.
• B. Change the reference speed used by OSPF in cost calculations on all switches within the path.
• C. Manually specify the OSPF Router ID on each switch within the path.
• D. Switch all routing protocols to RIPv2.

Answer: B

 

NEW QUESTION 38
Which option is used to configure Network Address Translation (NAT) to provide one-to-one mapping between local and global addresses?

• A. Overload
• B. Outside source static
• C. Inside source static
• D. PAT

Answer: C

 

NEW QUESTION 39
On which Dell EMC Networking switches can Multi-Chassis Link Aggregation (MLAG) be configured?

• A. Z-Series
• B. N-Series
• C. C9000 Series
• D. S-Series

Answer: B

 

NEW QUESTION 40
Which Border Gateway Protocol (BGP) version supports IPv6?

• A. BGPv4
• B. BGPv2
• C. BGPv3
• D. BGPng

Answer: A

 

NEW QUESTION 41
What is the valid range assigned to a client during a TCP connection?

• A. 20 - 25
• B. 40000 - 65535
• C. 1023 - 2024
• D. 443 - 1000

Answer: B

 

NEW QUESTION 42
A network administrator has a Dell EMC switch that has been configured with several VLANs. Each VLAN switch virtual interface (SVI) has an IP address assigned to it with each of them on different subnets. In addition, routing has been enabled on the switch.
Which action occurs when the switch receives a packet on one of its SVIs but the destination IP address of the packet does not match the IP address of that SVI?

• A. Switch duplicates the packet and sends it to all interfaces.
• B. Switch checks its routing table and forwards the packet accordingly.
• C. Switch drops the packet.
• D. Switch replies back to the source with an ICMP Reject packet.

Answer: B

 

NEW QUESTION 43
When configuring a switch, which CLI mode only supports limited show commands?

• A. EXEC
• B. EXEC Privilege
• C. Configuration
• D. Maintenance

Answer: A

Explanation:
Reference:
https://www.dell.com/support/manuals/us/en/04/poweredge-fx2/dell%20fn%20ioa% 20config_9.8.0.0_pub-v1/cli-modes?guid=guid-aeb7d44d-2413-4da8-b8b9-2f8a26bad435&lang=en-us

 

NEW QUESTION 44
A VLAN has been configured to have an IPv6 address and a stateless address autoconfiguration for clients. Which IPv6 address prefix will the default gateway have on a client?

• A. fd01::/64
• B. ff02::/8
• C. fe80::/64
• D. fe08::/64

Answer: C

 

NEW QUESTION 45
What is the default OSPF "hello interval"?

• A. 30 seconds
• B. 10 seconds
• C. 5 seconds
• D. 15 seconds

Answer: B

 

NEW QUESTION 46
How is a switch different from a hub?

• A. A switch operates at a lower, more efficient layer of the OSI model.
• B. A switch tracks MAC addresses of all connected devices.
• C. A switch decreases the number of broadcast storms.
• D. A switch does not include any latency into the frame transfer time.

Answer: B

 

NEW QUESTION 47
Which Ethernet frame forwarding method works best when the outbound ports run at the same speed as the inbound port?

• A. Store-and-forward
• B. Fragment-free
• C. Unicast
• D. Cut-through

Answer: D

 

NEW QUESTION 48
What is the Organizationally Unique Identifier (OUI) in the MAC address 00:C4:4F:23:AF:4A?

• A. 00:C4:4F
• B. 23:AF:4A
• C. 4F:23:AF:4A
• D. 00:C4:4F:23

Answer: A

 

NEW QUESTION 49
What accurately describes the comparison between stacking and VLT?

• A. VLT allows for more physical devices to appear as one virtual device than stacking does.
• B. Stacked switches and VLT peers allow "single pane of glass" management by maintaining a single control plane.
• C. Stacked switches share a common control plane while VLT peers maintain their own control plane.
• D. Both VLT and stacking allow devices to use different versions of firmware provided that the switch family/ series is the same.

Answer: C

Explanation:
Reference:
https://downloads.dell.com/manuals/common/dellemcnetworking_stacking_vs_vlt.pdf Introduction section

 

NEW QUESTION 50
Which Dell EMC Networking M-Series 10 GbE switch model supports a VLT?

• A. M6348
• B. MXL
• C. M6220
• D. M8024-K

Answer: B

Explanation:
Reference:
https://i.dell.com/sites/doccontent/shared-content/data-sheets/en/Documents/ PowerEdge_M_Series_Blades_IO_Guide.pdf

 

NEW QUESTION 51
Which Border Gateway Protocol (BGP) version supports IPv6?

• A. BGPv4
• B. BGPv2
• C. BGPv3
• D. BGPng

Answer: A

Explanation:
Explanation/Reference:

 

NEW QUESTION 52
......

EMC DEA-5TT1 Exam Syllabus Topics:

Topic	Details
Topic 1	Describe the DHCP and NTP service and explain the configuration steps Describe basic routing concepts and explain how to interpret a routing table
Topic 2	Switch Stacking, Dell EMC Campus, Datacenter, and Modular Switch Portfolio Describe the standards of how Ethernet operates and how addressing is used to move data on the Ethernet network
Topic 3	Describe IPv4 addressing and explain the process of using IPv4 in the network Switching Fundamentals and Creating a Switched Network
Topic 4	Describe the switch models that are part of the Dell EMC Campus, Datacenter Explain the purpose and basic operations of the OSI model
Topic 5	Describe Access Control Lists (ACLs) and Network Address Translation Security, Authentication, and ACLs Describe IPv6 addressing and explain the process of using IPv6 in the networkTransport Layer
Topic 6	Describe the options and processes of securing access to the network Identify and describe the differences between private and public IP addressing
Topic 7	Describe the key concepts of stacking and the hardware required to configure stacking using OS 6, OS 9, and OS 10 Identify and describe the differences between static and dynamic routing
Topic 8	Explain the reason for network switching and the process of moving frames within a switched network Describe the concepts and use cases for Layer
Topic 9	Describe the function of the Transport layers, how it supports host-to-host connectivity Explain the purpose and function of network devices such as switches and routers
Topic 10	Explain the routing process used by RIPv2, OSPF, and BGP Identify and describe the classifications of routing protocols and how they are used to route within and between autonomous systems

Get Top-Rated EMC DEA-5TT1 Exam Dumps Now: https://www.pass4cram.com/DEA-5TT1_free-download.html

Pass Your DEA-5TT1 Dumps Free Latest EMC Practice Tests: https://drive.google.com/open?id=1YthIjfk7qzkgZxv7QsUbE36Ob4EJ5TD1