Refer to the exhibits.


An administrator runs the reload failure command diagnose test deploymanager reloadconf 262 on FortiManager.
Why does the administrator receive an error message?

• A. The administrator must use the FortiGate name instead of the ID number.
• B. The administrator just recently added FortiGate HQ-NGFW as a model device.
• C. FortiManager requires the FortiGate serial number instead of the ID number.
• D. FortiManager does not support FortiOS version 7.0.

An administrator configures a new BGP peer in the FortiManager device-level database of FortiGate. They reinstall the policy package to the managed FortiGate device without any errors. However, when the administrator logs in to FortiGate, they do not see the BGP configuration changes.
What is the most likely reason why FortiManager did not push the BGP peer changes to FortiGate?

• A. The administrator must run a sanity check on FortiManager to make sure the database is not corrupted.
• B. The FortiGate firmware version is different from the FortiManager ADOM version.
• C. Fortigate has a BGP template assigned on the FortiManager database.
• D. The administrator must use the Install Wizard and select Install device settings only to push BGP settings

An administrator sees that the policy package status of HQ-NGFW-1 is Never Installed. What can you conclude from this status? Choose one answer

• A. The firewall policies were created or changed in the ADOM, and they need to be installed on the managed HQ-NGFW-1 for the first time.
• B. The policy package was never imported to the revision history after HQ-NGFW-1 was registered on FortiManager.
• C. The policies have not yet been retrieved from the HQ-NGFW-1 device-level database of FortiManager.
• D. The firewall policies exist only in the HQ-NGFW-1 device-level database, and no policy package has been assigned to the firewall.

While attempting to push a NetFlow configuration script through the FortiManager policy package: an administrator encounters an error stating that an object is unrecognized in line 4.

What must the administrator do to successfully apply the NetFlow configuration script and avoid the object unrecognized error?

• A. Make sure the user running the script has full access to the VDOM-AGEUSR.
• B. Run the script on the device database.
• C. Use metadata variables if they use VDOMs in the script.
• D. Create a normalized interface on the policy layer before running the script.

The administrator uses FortiManager to push a CLI script using the Remote FortiGate Directly (via CLI) option to configure an IPsec VPN. However, when running the script, the administrator receives the following error:
config vpn ipsec phase2-interface [parameter(s) invalid. detail: object mismatch] What must the administrator do to resolve the script error and successfully apply the IPsec configuration?

• A. Use IPsec templates to deploy provisioning templates.
• B. Add the end command after finishing the IPsec phase 1-interface configuration block.
• C. Add a second config vpn ipsec phase2-interface block without linking it to phase1.
• D. Run the script using the policy package or ADOM database method.